Mining Water Chiller
Mining Water Chiller
Mining Water Chiller
  • Stainless steel manufacture
  • Copper/Copper condenser
  • Blygold painting
  • Copeland compressor
  • Axial fan
  • Australian standards


The master module can work independently or together with up to 15 slave modules.

Hermetic Compressor

3-phase scroll type compressor, with built -in thermal overload cut-out and crankcase heater, mounted on rubber vibration dampers.

Axial Fan

External rotor type axial fans, equipped with three phase direct drive motors, low noise 8 poles, protection level IP54, provided with a protective outlet grille.


Evaporator built with high efficiency tube in tube type heat exchanger, factory insulated with flexible close cell material.


Condenser built with seamless internal screw thread copper tubes mechanically expanded into blue wavehydrophilic copper fins.

Refrigerant Circuit

Refrigerant circuit complete with charge valves, filter drier, sight glass, gas-liquid separator, thermostatic expansion valve, high & low pressure switch. The heat pump unit is also completed with 4 way valve, liquid receiver and one way valve.

Hydraulic Circuit

Hydraulic circuit built with galvanised pipe, complete with water discharge connection for tube in tube heat exchanger and flange type hydraulic connectors in two directions easy for connections from both side of the units.

Electrical Panel

Electric panel consists of: compressor contactor, fan motor contactor, compressor protection breaker, fan protection breaker, phase sequence relay and microprocessor with function display (optional).


  • Paddle flow switch
  • Metallic filter for hydraulic circuit
  • Water pump
  • Rubber anti-vibration mounting
  • BMS
  • Mild steel
  • Heat recovery 20-30%
  • Flange
  • Remote condenser
  • Four or six compressors
  • Plate heat exchanger
  • Aluminum condenser